The technical principle of the Guangdong Roadbuck 3D Wheel Alignment Machine is based on physical perspective and computer information processing technology. It achieves high-precision measurement by dynamically capturing the geometric changes of the wheels and generating data through algorithms. The specific technical principles can be divided into the following steps:1. Installation of Target Reflectors and Dynamic Shooting• Target Reflector Installation: Install four high-precision target reflectors on the vehicle's four rims. These reflectors serve as measurement reference points to ensure the accuracy of the measurement data.• Dynamic Shooting: As the wheels roll, the camera continuously captures the geometric patterns on the target reflectors. Unlike traditional static shooting, the Lubake 3D Wheel Alignment Machine uses dynamic continuous shooting technology to capture real-time changes in the wheels as they move.2. Computer Analysis and Calculation• Image Processing: The images captured by the camera are transmitted to the computer, which uses advanced image processing algorithms to analyze the geometric patterns in the images.• Parameter Calculation: The computer calculates changes in the geometric patterns to derive wheel and chassis alignment parameters, such as camber, toe, caster angle, etc. These parameters are key for adjusting the vehicle's suspension system and ensuring driving stability.3. Technology Iteration and Accuracy Improvement• Upgrade from Static to Dynamic: The Lubake 3D Wheel Alignment Machine has evolved from the first-generation static dual-point shooting to the second-generation dynamic continuous shooting technology. The first-generation equipment relied on static dual-point shooting, calculating two spatial coordinate points on the target's motion trajectory from two static photos, then fitting a motion curve. The second-generation equipment adopts dynamic continuous shooting technology, with camera resolution increased to 5 million pixels, producing clearer images that can be calculated from a single shot.• Multi-Point Trajectory Fitting: The second-generation device continuously photographs the target during motion, sending the images to the computer for computation. Curves fitted from dozens of points are more accurate than curves fitted from just two points and can eliminate individual jittered or misaligned points, greatly improving measurement accuracy, repeatability, and success rate.4. Hardware Configuration and Adaptability Optimization• High-Resolution Camera and Infrared Light Source: The Lubake 3D Wheel Alignment Machine is equipped with a high-resolution camera and infrared light source to ensure clear imaging of the target reflectors in low-light conditions.• Corrosion-Resistant Materials and Electronics-Free Target Boards: The hardware is made of corrosion-resistant materials, and the target reflectors contain no electronic components, require no batteries or data transmission, and serve purely as reflective targets, reducing failure rates and enhancing the device's durability.
Guangdong Roadbuck Electromechanical Equipment Co., Ltd.: ROADBUCK tire removal machine, balancing machine locator is designed for users who need more high-end use needs, the product after 20 years of precipitation and development, now it is quite mature, its products are complete. Moreover, it has MAXCARL auto maintenance mall, which can provide professional supporting services for various auto repair and maintenance service enterprises. The tire removal machine is mainly tilted and discless series, the balancing machine is mainly automatic measurement, and the locator focuses on diagnostic services. Therefore, consumers are positioned in professional wheel protection service centers, and professional users who have quality requirements for products.
Brand Website https://www.roadbuck3d.com/ 0757-86600197
2025-10-07