There are many reasons for the slow tire press of the tire removal machine

Tire removal machine (tire removal machine) slow tire pressure may be caused by a variety of reasons, the following are some possible causes and solutions:

 Reason analysis internal pressure is insufficient:

The pressure or hydraulic pressure inside the tire removal machine is insufficient, resulting in the failure to provide enough pressure when the tire is pressed, thereby slowing down the tire speed.

 Pad and tire contact is not close: If there is a gap between the pad and the tire or the contact is not close, it will cause excessive air to be produced when the tire is pressed, which will affect the tire speed.

There is a foreign body between the tire tread and the tire pad: If there is a hard object or foreign body between the tire tread and the tire pad, it will cause the contact area to be uneven, thus affecting the tire press speed.

Incomplete exhaust of the inner tube: When removing and assembling the tire, if the inner tube is not completely exhaust, it will affect the air pressure during tire press, and then affect the tire press speed. Pneumatic switch or air pressure problem (for pneumatic tire picker) : The air pressure of the pneumatic tire picker is abnormal or the pneumatic switch is abnormal, which may also lead to slow speed. Lack of lubricating oil: If the tire removal machine lacks the necessary lubricating oil, it may lead to increased friction between the moving parts, thereby reducing the tire press speed.

Solution: Check and increase the internal pressure: regularly check the internal pressure or hydraulic pressure of the tire removal machine to ensure that it is within the normal range.

If insufficient, the pressure should be increased in time. Adjust the position of the tire pad: check the contact between the tire pad and the tire. If there is a gap or the contact is not close, the position of the tire pad should be readjust to ensure that it is in close contact with the tire.

 Clean up foreign matter: Before pressing the tire, carefully check whether there is foreign matter between the tire tread and the tire pad, and clean it up if necessary.

Complete exhaust: When removing and assembling the tire, the valve switch of the inner tube should be loosened first, and then the tire will be loaded after the exhaust is finished, and the pressure of the inner tube will be adjusted when the tire is loaded.

 Check the pneumatic switch and air pressure: for the pneumatic tire scraper, it is necessary to regularly check whether the air pressure is normal and whether the pneumatic switch is abnormal, and if necessary, it should be repaired or replaced in time.

Add lubricating oil: Regularly check whether the moving parts of the tire removal machine lack lubricating oil, if lacking, it should be added in time to ensure that the friction between the moving parts is within the normal range. In summary, the reasons for the slow tire press of the tire removal machine may involve many aspects, and it is necessary to investigate one by one and take appropriate solutions. In the process of operation, it should be strictly in accordance with the instruction manual and safety operation procedures to ensure the safety and effectiveness of the operation.

2024-10-19